Small Parts & Accessories
What ships in the Small Parts Box, what each part does, and where it goes.
Most small components arrive in the Small Parts Box (hinges, shelf pins, brackets, rails, lighting components, small drawer hardware). If an item is too large for the Small Parts Box, it may be shipped loose or tucked inside a cabinet.
- Locate the Small Parts Box.
- Open every cabinet and check for loose parts stored inside.
- Gather all small parts and lay them out on a table.
- Group items by type to prepare for installation.
This step ensures installation readiness without over-inventorying accessories.
01–06 — Structure & Leveling

2" Spacers
Extend German-depth cabinets to standard U.S. depth for proper alignment. Required on all base and tall units unless clearly noted otherwise on approved plans.

Cabinet Leg Insert
Legs for base and tall cabinetry. Insert into leg mounts on base units and turn clockwise to raise or counter-clockwise to lower the unit during leveling.

Cabinet Connection Screws
Secure adjacent cabinets side by side during installation. Sized to pass through one cabinet wall without penetrating the other.

3" Hanging Rails
Used for range-wall cabinets and corner wall cabinets to allow clearance for venting, ductwork etc.

Wall Cabinet Spacer
To be used behind wall cabinet rails in case the wall has any waves or inconsistencies. Do not use more than 2 per side per unit.

Anti-Tip Safety Bracket
Provided for additional security of tall units and wall units to avoid any potential for tipping of cabinetry.
07–12 — Toe Kick & Panels

Toe Kick Clip (Front)
Provided to attach toe kick to the front of cabinets. Not suitable for return toe kick.

Toe Kick Clip (Return)
Provided to attach return toe kick at the side of base units. Not intended for use at front toe kick locations.

Vario Clips
Mounting clips provided for installation of panels at the back of islands and peninsulas.

Camar Bracket
Mounting brackets for UFK wall/vanity units.

Line N Rail Accessories
Installation tape, brackets and end caps for Line-N recessed handle applications.

Drawer Side Plate
Provided to cover the adjustment window at the sides of drawers.
13–18 — Fronts, Shelves & Finishing

Push To Open Mechanism
Provided for doors and drawers on handless designs. Refer to plans for locations required.

Push To Open Mechanism (integrated)
Provided for doors and drawers on handless designs. Refer to plans for locations required. Drilling jig included.

Front and Rear Shelf Pins
Internal shelves have a drilled location at the rear to host shelf pins with a protruded nib to secure the shelves during regular use. Flat shelf pins should be utilized at the back of internal shelves.

Door / Drawer Bumpers
Provided to minimize clatter and collision noise during operation of doors and drawers.

Mounting Adjustment Hole Covers for Wall Units
Provided to cover the adjustment holes at the back of wall units once the cabinet has been leveled and secured to neighboring units.

Base Unit Leg Adjustment Plug
Provided to fill the access hole within base units once base legs have been adjusted in height to level cabinets.
Parts shown ship per project — quantities and inclusions follow the approved plans. Missing or damaged parts: customersupport@nobilia-america.com.