Renovation Toolkit · Form 01

Measure Your Space

All measurements in inches. Cabinets are built to these numbers — measure twice.

1PROJECT

Client name

Date measured

Project address

Room being measured

Measured by (name)

Phone / email

Project typeRenovationNew build

2THE ROOM

Draw the room on paper. Label every wall (A, B, C…). Check each item as it appears on your drawing:

Full room outlineAll walls labeledDoors and windowsDoor swing directionsOpenings to adjacent roomsAny irregular geometry

Photo of the drawing takenPhotos of existing plans (if any)

3WALLSone row per wall · measure corner to corner

Wall	Corner to corner (in)	At counter height (in)	Same higher up?	If not — where it changes
A
B
C
D
E
F

4DOORS + WINDOWSeverything that interrupts a cabinet run

Door	W × H (in)	Trim depth	Swing direction	Dist. to left corner	Dist. to right corner
D1
D2
D3
D4

Wind.	W × H (in)	Sill height	Head height	Trim depth	Dist. left	Dist. right
W1
W2
W3
W4

More doors or windows than rows? Add rows as needed — or continue on a second sheet. Every opening counts.

5UP HIGHverticals determine maximum cabinet height

Ceiling height — spot 1 / spot 2 (in)

If it varies — highest / lowest (in)

Soffits — height / depth (in)

Beams / dropped areas — height / depth (in)

Anything else hanging low

6UTILITIEScenterlines decide where cabinets and appliances land

Utility	On drawing?	Centerline marked?	Notes + location
Sink water + drain
Dishwasher
Refrigerator water
Electrical affecting layout
Gas
Vent / hood duct
HVAC
Panels or shut-offs

7CONDITIONS

FloorFlatSlight slopeMajor slope

WallsMostly plumbNoticeable deviation

Anything affecting installation accuracy

8NOTES FOR THE DESIGNER

Constraints or conflicts

Coordination with other trades

Special conditions

Customer comments

9CONFIRM BEFORE SENDING

Every wall labeledRoom outline drawnEvery wall measured — both heightsDoors + windows with distances to cornersVerticals — ceiling, soffits, beamsEvery utility centerlinedFloor + wall conditions notedPhotos of the whole room sent

10SIGN-OFF

Best case: the installer doing the install takes these measurements — and signs them.

Installer signature

Date

Customer signature

Date

Handoff: send this form and your photos to your designer.

Form 01 · Measure Your SpaceWe're here to help · customersupport@nobilia-america.com

This resource is optional and provided for general guidance only. It reflects suggestions based on industry standards. No information is collected or stored through this document, and no responsibility is assumed for its use. All work should be performed by qualified professionals and verified against project-specific documents and site conditions.